Hitachi IR.LINK User Manual page 58

<Setting items on the [Set slot information] window>
I/O type: There are 7 I/O types that can be selected. Select an I/O type according to the I/O
module installed in each slot. The default I/O type at new registration is "Delete."
Delete: Select "Delete" to delete the registered I/O module.
DI: Select DI when the module being installed is a digital input.
DO: Select DO when the module being installed is a digital output.
AI: Select AI when the module being installed is an analog input and the mode of the
module is set to 1.
AO: Select AO when the module being installed is an analog output and the mode of the
module is set to 1.
S10 AI (4ch): Select S10 AI (4ch) when the module being installed is an analog input and
S10 AO (4ch): Select S10 AO (4ch) when the module being installed is an analog output
S10 PCT (pulse counter): Select S10 PCT when the module being installed is a pulse
Transfer byte count: Set the number of bytes to be transferred in the range of /1 to /10
Transfer address: Set the beginning address of the area to be transferred. Table 4-2 shows
(8) After completing the setting, click the
(Figure 4-7). To cancel the setting, click the
is clicked, the information edited on the [Edit information] window (Figure 4-7), Edit station
information window (Figure 4-8), and [Set slot information] window (Figure 4-9) is written
into the memory of the IR.LINK module of the PCs. When the
clicked, the edited information is discarded and the [Edit information] window ends.
the mode of the module is set to 2.
and the mode of the module is set to 2.
counter.
(hexadecimal input. However, "/" is not required.) If a value other
than /1 to /10 is specified, the message dialog box " The number of bytes
to be transferred is out of range (/01 to /10)." is displayed.
areas that can be specified.
OK button on the [Edit information] window
Cancel button. When the
4-15
4 OPERATION
OK button
Cancel button is