Grounding Shielded Cable - Danfoss VLT Decentral Drive FCD 302 Operating Manual

VLT® Decentral Drive FCD 302
Operating Guide
Do not install power factor correction capacitors between the drive and the motor. Do not wire a starting or pole-changing de-
vice between the drive and the motor.
1. Connect the motor to terminals 96, 97, 98.
2. Connect ground to PE terminal.
3. Make sure that the shield of the motor cable is properly grounded at both ends (motor and drive).

4.7.1 Grounding Shielded Cable

Grounding clamps are provided for motor and control wiring.
Illustration 15: Grounding Clamp for Motor and Control Wiring (Small Unit)
Danfoss A/S © | 2020.07
N O T I C E
Electrical Installation
AQ267036816112EN-000101 / 130R0208 | 25