Network Parameters - Lenze SMV Series Operating Instructions Manual

Commissioning
4.5.6

Network Parameters

Code
No. Name
Network Protocol
p400
Module Reset
P403
EN
Current Network
P405
Fault
Network Address
P410
Network Baud Rate
P411
Network Data
P412
Format
Network Timeout
P420
Action
P421 Network Timeout
P430 Display Override
Network Messages
P470
Received
Network Messages
P471
Transmitted
Modbus Messages
P498
with Exception
Invalid Modbus
P499
Messages
32
Possible Settings
Default Selection
2
0 Not Active
1 Remote Keypad
2 Modbus RTU
3 CANopen
4 DeviceNet
5 Ethernet
6 Profibus
7 Lecom-B
8 I/O Module
0 0 No Action
1 Activate Modbus related settings
0
0 No Fault
1 F.nF1
2 F.nF2
3 F.nF3
4 F.nF4
5 F.nF5
6 F.nF6
7 F.nF7
8 F.nF8
9 F.nF9
11
1 - 247
3 0 2400 bps
1 4800 bps
2 9600 bps
3 19200 bps
4 38400 bps
5 57600 bps
6 125200 bps
2 0 8, N, 2
1 8, N, 1
2 8, E, 1
3 8, O, 1
1 0 No action
1 Stop (P111)
2 Quick Stop
3 Controller Inhibit
4 Trip Fault, F.ntF
0.0 {sec}
15.0
0.0 {sec}
3.0
0 9999
0
NOTE: When the number of messages exceeds 9999, the counter resets and
resumes counting from 0.
0 9999
0
NOTE: When the number of messages exceeds 9999, the counter resets and
resumes counting from 0.
0 9999
0
NOTE: When the number of messages exceeds 9999, the counter resets and
resumes counting from 0.
0 0 9999
NOTE: When the number of messages exceeds 9999, the counter resets and
resumes counting from 0.
This parameter setting is based upon the
network or I/O module that is installed.
Transition 0 -> 1 activates Modbus
related settings in P410, P411, P412 Value
automatically returns to 0
Network triggered fault by writing into
register 2107
Overall I/O Message Timeout
Modbus Node address.
After modification, activate with P403
After modification, activate with P403
After modification, activate with P403
Active when drive is in network control
mode.(Register 2100, bit 5 set)
Sets the reaction to network faults caused
by network timeout or direct writing into
the network fault register 2007.
300.0
10.0
(Read only) Valid Network messages received.
(Read only) Messages transmitted by the drive.
(Read only) Modbus messages generating exception
responses.
(Read only) Invalid Messages received by the drive.
IMPORTANT
EDBSV571 EN 1.0