Lenze SMV Series Operating Instructions Manual page 37

Modbus Reg. Name
2006 Drive Load
2007 Output Power
2008 Heatsink
Temperature
2009 DC Bus Voltage
2010 Digital Inputs
2011 Actual Torque
2012 Actual Setpoint
Frequency
2013 Reserved
2014 Reserved
2015 Reserved
2016 Reserved
2017 Reserved
2018 Reserved
2100 Drive Control Word
See bit details below
2101 Network Frequency
Setpoint
2102 Network Analog
Output
2103 Digital/Relay Output Read/Write
2104 Network PID
Setpoint
2105 Network PID
Feedback Reference
2106 Network Torque
Setpoint
2107 Trigger Network
Fault
2108 Override Display Dig
1 and 2
2109 Override Display Dig
2 and 3
2110 Reserved
EDBSV571 EN 1.0
Access Type Range of adjustment
Read only 0-255 [%]
Read only 0-655.00 [0.01 KW]]
Read only 0-150 [°C]
Read only 0-1500 [VDC]
Read only Word representing
misc. binary statuses
Read only 0-500%
Read only 0 – 65535 [0.1Hz]
Read only 0 – 0xFFFF
Read only 0 – 0xFFFF
Read only 0 – 0xFFFF
Read only 0 – 0xFFFF
Read only 0 – 0xFFFF
Read only 0 – 0xFFFF
Read/Write 0 – 0xFFFF
Read/Write 0 – 65535 [0.1Hz]
Read/Write 0 – 1000 [0.01 VDC]
Reserved
Read/Write P204...P205
Read/Write P204...P205
Read/Write 0-100%
Read/Write 0-9
Read/Write 0-0xFFFF
Read/Write 0-0xFFFF
Read/Write 0-0xFFFF
Commissioning
Important
Motor load as % of drive's output
current rating (P507)
See reference below
Torque as % of motor rated torque
(vector mode only)
Resolution 0.1Hz (ex. 345 – 34.5Hz)
Resolution 0.1Hz (ex. 345 – 34.5Hz)
Sets the output voltage level at
terminal Tb30. P150 must be set to 9
'Network Control'
Reserved – User controlled digital
output and relay are not available
Min/max user feedback scaling
Signed Feedback Display Units
Min/max user feedback scaling
Signed Feedback Display Units
Writing into this register triggers drive
fault 'F.Fn1...9.
To clear it, first write 9 into this register.
High byte represents the 8 LED
segments of digit 1 of Drive display.
Low byte represents the 8 LED
segments of digit 2 of Drive display.
High byte represents the 8 LED
segments of digit 3 of Drive display.
Low byte represents the 8 LED
segments of digit 4 of Drive display.
After writing this register (2009), if both
values in reg. 2108 and 2109 are not
equal 0 the Drive display will switch
to display the override value. See note
below with example.
EN
35