Installation Guide Linear Motors
3.5 "Moving slider" installation
In a "moving slider" installation, the stator is fixed and the slider is the moving part.
The load, borne by a linear guide, is attached directly to the end of the slider. In order to compensate for
misalignment, spherical axial bearings consisting of spherical washers and conical seats (see the section
Slider mounting kits) are used to connect to the load. The mounting kit of slider and an oversized hole for the
screw make it possible to adjust a radial and angle offset.
3.6 "Moving stator" installation
Spherical washer and
conical seat
Page 10 / 40
Stator
Slider
Linear guide
Stator
Linear bearing
P01-23 / P01-37 / P01-48
Spherical washer and
conical seat
Linear bearing
Mounted payload with radial and angle offset
Slider
Linear guide
ENG
Floating
bearing
NTI AG / LinMot