Toro Workman 3000 Series Service Manual page 222

12.Carefully install rear flange onto pump assembly.
13.Install the four (4) screws (item 17) with lock washers
and hand tighten.
IMPORTANT: Prevent damage when clamping the
pump into a vise; clamp on the front cover only.
Also, use a vise with soft jaws.
14.Place front cover of the pump into a vise with soft
jaws and alternately torque the cap screws 220 in--lb (25
N--m).
Hydraulic System
15.Remove pump from vise.
16.Place a small amount of clean Dexron III ATF in the
inlet of the pump and rotate the drive shaft away from the
inlet one revolution. If any binding is noted, disassemble
the pump and check for assembly problems.
Page 9 - - 29.3 Rev. D Workman 3000/4000 Series