Toro Workman 3000 Series Service Manual page 125

34.Apply multi–purpose grease to O–ring and insert O–
ring into groove of transaxle case. If installing P.T.O., in-
sert 2 dowel pins in transaxle case. Install P.T.O. or
cover. Tighten nut with lockwasher (Item 2) and cap
screws (Item 1) to a torque from 11 to 13 ft–lb (15 to 17
N–m).
35.Install bell housing and secure with cap screws (Item
2). Tighten cap screws to a torque from 18.5 to 22 ft–lb
(24.5 to 29.5 N–m).
36.Install extension spring (Item 1).
Workman 3000/4000 Series
1
Page 6 – 53
2
3
1
Figure 113
2
Figure 114
Drive Train