Toro Workman 3000 Series Service Manual page 277

IMPORTANT: Make sure retaining ring (3) is proper-
ly seated in the drive shaft (19) groove. Pull clutch
out from the transaxle to make sure that it holds in
place. Replace ring if bent or damaged.
5. Secure clutch to front drive shaft (19) with retaining
ring (3).
IMPORTANT: Make sure rubber side of the seal plug
(2) faces towards the clutch when installing.
6. Insert seal plug (2) into the housing and race (5) us-
ing a driver.
Workman 4000 Series
7. Secure clutch shaft to housing and race (5) with lock
washers (16) and hex socket head screws (17).
8. Lower front wheels to ground.
9. Make sure drain plug is installed properly to the
transaxle. Fill transaxle with Dexron III ATF (see Opera-
tors Manual).
10.Install differential drive shaft (18) to clutch shaft (1)
and the front differential (see Differential Drive Shaft
Installation).
Page 10 – 35 Front Wheel Drive (4WD)