Hydraulic Manifold (Optional High Flow Hydraulic Kit) - Toro Workman 3000 Series Service Manual

Hide thumbs Also See for Workman 3000 Series:
Table of Contents

Advertisement

Hydraulic Manifold (Optional High Flow Hydraulic Kit)

Removal (Fig. 41)
1. Park vehicle on a level surface, raise bed, shut en-
gine off and engage the parking brake.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
CAUTION
Before performing any service or repair on hy-
draulic system components, relieve system
pressure to avoid injury from pressurized hy-
draulic oil. Stop the engine, remove key from the
ignition switch, rotate the steering wheel in both
directions, lower or support the bed and operate
other hydraulic accessories.
3. Label and disconnect hydraulic hoses from hydraulic
manifold. Install caps or plugs in hoses to prevent con-
tamination and leakage of hydraulic oil. Install plugs in
manifold ports.
4. Remove manifold from vehicle using Figure 41 as a
guide.
Installation (Fig. 41)
1. Install manifold to vehicle using Figure 41 as a guide.
2. Replace o–rings on hydraulic hoses and fittings. Re-
move caps and plugs from hoses and fittings. Connect
hydraulic hoses to manifold.
3. Check oil level in reservoir (see High Flow Hydraulic
Kit Installation Instructions). Add correct oil if necessary.
Valve Cartridge Service (Fig. 42)
1. Make sure the entire outer surface of the manifold is
clean before removing the valve.
2. For solenoid cartridge valve, remove nut securing
solenoid to the cartridge valve. Carefully slide solenoid
off the valve. Locate and retrieve seals from top and bot-
tom of coil.
IMPORTANT: Use care when handling the valve car-
tridge. Slight bending or distortion of the stem tube
can cause binding and malfunction.
3. Remove cartridge valve with a deep socket wrench.
Note correct location for o–rings, sealing rings, and
backup rings. Remove and discard seal kit.
Hydraulic System
RIGHT
FRONT
7
1. Hydraulic manifold
2. O–ring
3. Hydraulic fitting
4. O–ring
50 to 55 in–lb
(5.6 to 6.2 N–m)
30 to 35 ft–lb
(41 to 47 N–m)
1. Retaining nut
2. Solenoid seal
3. Solenoid coil
4. Solenoid cartridge valve
Page 9 – 46
6
2
Figure 41
5. Cap screw
6. Lock nut (2 used)
7. Engine mount bracket
1
2
3
2
4
5
6
7
8
Figure 42
5. Seal kit
6. Manifold body
7. Seal kit
8. Relief valve cartridge
Workman 3000/4000 Series
2
1
3
4
5
4
3
30 to 35 ft–lb
(41 to 47 N–m)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman 4000 series

Table of Contents