Brake Master Cylinder - Toro Workman 3000 Series Service Manual

Brake Master Cylinder

RIGHT
FRONT
1. Brake master cylinder
2. Cap screw (2 used)
Removal (Fig. 9)
1. Remove cotter pin from the clevis pin that connects
master cylinder to brake pedal.
2. Clean hydraulic brake line area of master cylinder to
prevent contamination. Remove both brake lines from
master cylinder. Cap ends of brake lines and position
them away from master cylinder.
3. Remove two (2) cap screws and flange nuts that se-
cure master cylinder to vehicle frame.
4. Pull master cylinder from vehicle.
Chassis
5
Figure 9
3. Clevis pin
4. Cotter pin
Page 7 – 20
2
1
3
4
6
5. Flange nut (2 used)
6. Brake pedal
Installation (Fig. 9)
1. Position master cylinder to vehicle frame and secure
with two (2) cap screws and flange nuts.
2. Remove plugs from brake lines. Install brake lines to
master cylinder.
3. Make sure that master cylinder push rod is fully ex-
tended. Connect push rod clevis to brake pedal with cle-
vis pin and cotter pin.
4. Bleed brakes (see Bleed Brake System).
CAUTION
After servicing the brakes, always check the
brakes in a wide open, level area that is free of
other persons and obstructions.
5. Check brake operation.
Workman 3000/4000 Series