10.Install PTO cover:
A. Insert new oil seal into PTO cover. Apply multi–
purpose grease to lip of oil seal.
B. Insert two (2) alignment pins into PTO housing.
C. Apply silicone sealant onto mating surface of PTO
cover.
D. Install PTO cover. Tighten cap screws and nut
with lockwasher to a torque from 18 to 22 ft–lb (24.5
to 29.5 N–m).
11. Install PTO to transaxle (see PTO Removal and
Installation in this chapter).
Workman 3000/4000 Series
Page 6 – 63
Figure 145
Drive Train