Using Bed Safety Support - Toro Workman 3000 Series Service Manual

Using Bed Safety Support

Many of the procedures shown in this manual re-
quire raising and lowering the bed. The following
precautions must be taken or serious injury or
death could result.
WARNING
Before servicing or making adjustments to the
vehicle, stop engine, set parking brake and re-
move key from ignition switch. Any load mate-
rial must be removed from bed or other attach-
ment before working under raised bed. Never
work under a raised bed without positioning
bed safety support on a fully installed cylinder
rod.
After work is completed, remove bed safety sup-
port, insert into storage brackets on back of ROPS
panel and lower bed.
1. Raise bed until lift cylinders are fully extended.
2. Remove bed safety support from storage brackets
on back of ROPS panel.
3. Push bed safety support onto cylinder rod, making
sure support end tabs rest on end of cylinder barrel and
on cylinder rod end (Fig. 3).
4. To store bed safety support, remove support from
cylinder and insert into storage brackets on back of
ROPS panel.
5. Always install or remove bed safety support from
outside of bed.
6. Do not try to lower bed with bed safety support on cyl-
inder: cylinder and bed damage may occur.
Safety
1
1. Bed safety support
2. Cylinder barrel
Page 1 – 6
3
2
Figure 3
3. Bed
Workman 3000/4000 Series