Front Shock Absorber Replacement
1. Remove lower and upper lock nuts, then remove
shock absorber and washers. Note that washers on up-
per end of shock absorber are different. Washers on
lower end of shock are identical.
2. Insert two (2) new rubber bushings into each end of
new shock absorber. Insert spacer into ram (lower) end
of shock absorber.
3. Install inner washer onto stud above control arm.
4. Install new shock absorber with ram end down and
secure upper end with outer washer and lock nut.
5. Insert capscrew down through angled hole in control
arm tower. Install washer onto cap screw and slide
shock absorber onto cap screw. Install second washer
onto capscrew and secure with lock nut.
Chassis
1
3
9
1. Rubber bushing
2. Spacer
3. Inner washer
4. Shock absorber
5. Outer washer
Shock absorber
Page 7 – 28
7
10
6
5
4
8
2
1
8
Figure 21
6. Lock nut
7. Cap screw
8. Washer
9. Lock nut
10. Control arm tower
Figure 22
Workman 3000/4000 Series