Inspection - Toro Workman 3000 Series Service Manual

Inspection

1. Thoroughly clean and dry all parts.
2. Use emery cloth to remove nicks and burrs from all
parts.
3. Measure clearance between groove on shift collar
and shifter block. Replace shifter block if clearance ex-
ceeds .039 in. (1.0 mm).
4. Measure I.D. of input shaft bushing (Item 1). Replace
bushing if I.D. exceeds .673 in. (17.10 mm).
5. Measure O.D. of bushing area on input shaft. Re-
place shaft if O.D. is less than .667 in. (16.95 mm). In-
spect surface of bushing area for scoring or damage.
6. Inspect surface of oil seal area on output shaft for
wear or damage.
Drive Train
Page 6 – 58
Figure 127
1
Figure 128
Figure 129
Figure 130
Workman 3000/4000 Series