Toro Workman 3000 Series Service Manual page 134

8. Install PTO intermediate shaft sub–assembly:
A. If removed during disassembly, insert bearing
(Item 3) into PTO housing.
B. Put gear (Item 2) on mating gear.
C. Move gear until bores of gear and bearing line up.
D. Insert intermediate shaft sub–assembly (Item 1).
Apply grease to intermediate shaft to aid assembly.
9. Insert PTO shaft assembly (Item 1) into bearing
housing of PTO housing.
Drive Train
Page 6 – 62
3
Figure 142
1
2
Figure 143
Figure 144
Workman 3000/4000 Series
1