Toro Workman 3000 Series Service Manual page 103

27.Disassemble fork shaft assemblies:
A. Remove lock pin (Item 1) from 2nd–3rd fork shaft
assembly.
B. Remove shift fork (Item 2) from fork shaft.
C. Remove lock pin (Item 1) from 1st–R fork shaft
assembly.
D. Remove fork (Item 2) from fork shaft.
28.Disassemble Hi–Lo fork shaft assembly:
A. Remove shift fork (Item 1), steel ball (Item 2) and
spring (Item 3) from Hi–Lo shift fork assembly.
B. Remove E–ring (Item 4).
29.Disassemble differential gear assembly:
A. Use a bearing puller to remove bearing (Item 1)
from differential case.
B. Remove snap ring (Item 2).
C. Use a bearing puller to remove bearing (Item 3)
and slider (Item 4).
D. Loosen screws (Item 5) from ring gear.
E. Remove ring gear (Item 6) from differential case
and remove 2 dowel pins (Item 7).
F. Drive lock pin (Item 8) out of pinion shaft (Item 9).
G. Remove pinion shaft (Item 9) from differential
case.
H. Remove 2 differential pinions (Item 10) and 2 lin-
ers (Item 11).
I. Remove L.H. side gear (Item 12), R.H. side gear
(Item 13) and 2 liners (Item 14).
Workman 3000/4000 Series
1
2
3
4
Page 6 – 31
Figure 50
5
4
3
2
Figure 51
Figure 52
11
10
6
9
8
7
14
13
1
5
1
Figure 53
Drive Train
12
14
10
11