Rear Shock Absorber Replacement - Toro Workman 3000 Series Service Manual

Rear Shock Absorber Replacement

1. Remove lower and upper lock nuts, then remove
shock absorber and washers from vehicle.
2. Insert two (2) new rubber bushings into each end of
new shock absorber.
3. Install one large washer onto each shock absorber
mounting stud.
4. Install new shock absorber with ram end down. Se-
cure each end with with large washer and lock nut.
Workman 3000/4000 Series
1. Rubber bushing
2. Large washer
3. Shock absorber
Page 7 – 29
2
1
3
2
5
4
1
Figure 23
4. Large washer
5. Lock nut
Shock absorber
Figure 24
Chassis
4
5