3: Ac Power Connection - Johnson Controls IFI-WS Installation And Operation Manual

Connections
2.2.3 AC Power Connection
Connect AC power to the IFI-WS computer as follows:
1. Verify that the voltage selection switch is in the correct position.
2. Verify that the rear-panel power switch is set to the ON (|) position.
3. Verify that the functional power switch, located behind the locking front door, is set to the OFF (O)
position.
4. Remove the two screws shown below and retain for later use.
5. Cut the end off of the factory supplied AC power cord and remove outer insulation.
6. Plug the power cord into the IFI-WS computer's AC power receptacle.
7. Feed the cut end of the power cord through the hole in the power cord locking bracket (PCLB)
reinstall the two screws removed earlier.
8. Strip the insulation from the ends of the three AC power cord wires and connect them to the UPS in
accordance with manufacturer's instructions.
IFI-WS Installation and Operation Manual – P/N LS10050-000JC-E:A 12/11/2014
Remove
Cut Here
Remove
Remove Insulation
Hardware Configuration
23