Notes For Your Safety; General Safety Instructions; Danger For Users, Patients, And Third Parties - Atmos iQam Operating Instructions Manual

2

Notes for your safety

Please read and pay attention to the safety instructions prior to using the
product.
2.1

General safety instructions

Use only accessories and options that are specifically suited for combination with
the product and that meet the performance and safety requirements.
The PC used must comply with the standard IEC 60950-1.
If you wish to connect more than one device or application part, you must always
observe their safety instructions.
The product uses vibration as haptic feedback. When used in combination with
the ATMOS Capture Suite software, the vibration can be deactivated.
2.2

Danger for users, patients, and third parties

Electric shock due to unsuitable power connection, incorrect handling of
the product, or damage to product components
Slight injuries are possible.
• Prior to each use, check for damage to the device and the camera cable.
Do not operate the device if you notice any damage. In this case, clean and
disinfect the device and send it to ATMOS for repair.
• The device can only be disconnected from the power supply by pulling out
the camera cable.
• Position the device so that it can always be disconnected from the power
supply easily.
• Never touch the plug or power cable with wet hands.
• Never touch the device's interfaces and the patient at the same time!
• Use only original accessories and original spare parts from ATMOS.
• Follow the instructions regarding periodic tests in chapter "6.1 Periodic tests"
on page 21.
• Assembly, new settings, alterations, extensions, and repairs may only be
carried out by authorized persons.
• Do not modify the device without the manufacturer's permission.
8 Notes for your safety