Capturing A Photo; Setting The White Balance - Atmos iQam Operating Instructions Manual

4. Tap again 2x on the status indicator. (You need the ATMOS Capture Suite
software to use this function.)
» The video recording stops.
» The status indicator lights up blue.
 You can also start and stop the video recording via the software or a foot
switch (only with the ATMOS Capture Suite software).
Pausing a recording
You need the ATMOS Capture Suite software to use this function.
1. Pause the recording. Follow the operating instructions for the ATMOS
Capture Suite software.
» The status indicator flashes red.
» Two vertical red bars appear on the monitor.
4.7

Capturing a photo

1. Launch the software.
2. In the software, select the appropriate mode for recording photos.
3. Tap 2x on the status indicator. (You need the ATMOS Capture Suite software
to use this function.)
» The photo is taken.
» The status indicator lights up blue briefly.
» The camera vibrates 2x.
 You can also record a photo via software or a foot switch (only with the
ATMOS Capture Suite software).
4.8

Setting the white balance

You need the ATMOS Capture Suite software to use this function.
 Do not set the white balance under fluorescent light because otherwise the
result may not be satisfactory.
1. Launch the ATMOS Capture Suite software.
2. Turn on the light source and wait until the light has stabilized.
3. Set the white balance preferably under natural lighting conditions. (If
possible, point the camera out of the window.) Otherwise, use a white-gray
surface.
4. Open the O
5. Select the
6. Click the W
14 Operation
window.
ptiOns
Q tab.
i am
button.
hite balance