Jam Code When Making Multiple Copies Due To Foreign Material That Had Fallen Into The Gripper Track (Staple/Booklet Finisher-A1) - Canon imageRUNNER ADVANCE C5000 Series Technical Workbook

[Reference]
- Curl correction level is constantly adjusted to suit the characteristics of a paper. However, if the paper curl
is not corrected properly, you can manually adjust the curl correction level to accommodate the environment
and the characteristics of the paper, such as moisture in the paper.
- You can change the level of curl correction to suit the characteristics of the paper.
- Paper curl is negated by adjusting the paper in the opposite direction that is curled. Make test copies or
prints on the paper that you have adjusted and check the level of curl correction.
[Caution]
- Note that this feature may affect paper feeding. Since increasing the value to a great extent may cause
paper jams, adjusting the values in small increments is recommended.
- If you adjust the level of curl correction in Paper Type Management Settings in Preferences (from
Settings/Registration), make sure to reset the value in Adjustment/Maintenance (from the Additional
Functions screen) to "0".
- Depending on the environment where the paper is stored, the condition of the paper, such as moisture in
the paper, may differ. If the condition of the paper is different than usual, you can adjust the curl correction
level of each paper source individually for a better result.
- "Correct Curl for Each Paper Drawer" can be adjusted if the finisher is attached.
Symptom
112F Jam Code when Making Multiple Copies due to foreign material that had fallen into the gripper track
(Staple/Booklet Finisher-A1)
Description
The 112F jam code is an error avoidance jam. There were no error codes in service history. This code would
come up only when running multiple pages in the finisher. Single pages worked correctly.
While watching the gripper unit it was noticed that the gripper unit did not grab the pages and exit them onto
the finisher tray. Then the jam would occur. The gripper unit would not pull back into the finisher far enough
to go behind the rear edge of the paper. The gripper unit need to go back all the way behind the stack of
pages so it can close on the paper and push it forward to exit the stack out on to the tray.
- 112F: Detected error (E514/E530/E532/E535/E537/E540/E542/E568/E56D/E578/E57B/E57C/E583/E584)
104