Connecting Modules And Control Software; Connecting Agilent 1200 Series Modules - Agilent Technologies 1200 Series Manual

Connecting Modules and Control Software

Use of unsupplied cables
WA R N I N G
Using cables not supplied by Agilent Technologies can lead to damage of the
electronic components or personal injury.
➔

Connecting Agilent 1200 Series modules

1 Place the individual modules in a stack configuration as shown in
2 Ensure the power switches on the front of the modules are OFF (switches
3 Plug a CAN cable into the CAN connector at the rear of the respective
4 Connect the CAN cable to the CAN connector of the next module, see
5 Press in the power switches to turn on the modules.
1200 Series Quarternary Pump User Manual
Never use cables other than the ones supplied by Agilent Technologies to ensure
proper functionality and compliance with safety or EMC regulations.
on page 33.
stand out).
module (except vacuum degasser).
Figure 6 on page 34.

Connecting Modules and Control Software

Installing the Pump
Figure 5
3
39