Agilent Technologies 1200 Series Manual page 37

2 Ensure the power switch on the front of the module is OFF (switch stands
3 At the rear of the module move the security lever to its maximum right
4 Connect the power cable to the power connector at the rear of the module.
5 Connect the required interface cables to the quaternary pump, see
1200 Series Quarternary Pump User Manual
out).
Figure 7 Front of module
position.
The security lever will prevent that the cover is opened while the power
cord is connected to the module.
"Connecting Modules and Control Software"
Installing the Pump
Installing the Quaternary Pump
on page 39.
3
37