Agilent Technologies 1200 Series Manual page 35

1
2
3
4
5
6
If a single stack configuration becomes too high, e.g. if an additional module like a G1327A
N O T E
ALS Thermostat is added or if your bench is to high, a two stack configuration may be a
better setup. Separate the stack between pump and autosampler and place the stack
containing the pump on the right side of the stack containing the autosampler.
1200 Series Quarternary Pump User Manual
Analog signal to recorder, for PN see
CAN Bus cable for inter module communications
5181-1561 (0,5m)
5161-1519 (1,0m)
CAN Bus cable to handheld controller
Remoter cable
5061-3378
Pressure output to recorder, for PN see
AC power
GPIB or LAN to control software, for PN see
Optimizing the Stack Configuration
"Cable Overview" on page 120
"Cable Overview" on page 120
"Cable Overview" on page 120
Installing the Pump
3
35