Program Example For Reading The Inverter Status - Mitsubishi Electric 800 Series Instruction Manual

8.1

Program example for reading the inverter status

The following program turns on Y00 of the output unit when station 1 inverter is running
X0 X0F X1
0
M0 X1002
7
Inverter running (RX02)
10
RXF
One
station
RX1F
*1 These signals are initial values. You can change output signals using Pr.190 to Pr.196, Pr.313 to Pr.315 (output terminal function
selection).
*2 The signals are fixed. They cannot be changed using parameters.
84
PROGRAMMING EXAMPLES
SW80.0
X100F
Remote input
b15
to RX0
0
to RX10
Inverter status
b0: During forward rotation 
b1: Reverse running 
b2: Running (terminal RUN function) 
b3: Up to frequency 
b4: Overload alarm 
b5: No function (terminal NET Y1 function) 
b6: Frequency detection (terminal FU function) 
b7: Fault (terminal ABC function) 
b8: No function (terminal NET Y2 function) 
b9: No function (DO0) 
b10: No function (DO1) 
b11: No function (DO2) 
M0
Y30
END
b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
0 0 0 0 0 0 0
[Inverter status]
Check the data link status of the station 1
Turn on the output unit (Y00)
X1000
0 0 0 0 0 0 0 0