Inverter Reset - Mitsubishi Electric 800 Series Instruction Manual

4.4

Inverter reset

 Operation conditions of inverter reset
Which resetting method is allowed or not allowed in each operation mode is described below.
Inverter reset (Refer to
Reset from the
Error reset (RY1A) at inverter fault
network
(Refer to page
Turn on the RES signal (terminal RES) of the inverter
Switch off inverter power
Inverter reset
Reset on the
operation panel
Reset at inverter fault
*1 Inverter reset can be made any time.
*2 Reset can be made only when the protective function of the inverter is activated.
NOTE
• When a communication line error has occurred, reset cannot be made from the network.
• The inverter is set to the External operation mode if it has been reset in Network operation mode in the initial status. To
resume the network operation, the inverter must be switched to the Network operation mode again. Set a value other than
"0" in Pr.340 to start in the Network operation mode. (Refer to
• Communication continues during inverter reset. (The inverter cannot be controlled for about 1 s after release of a reset
command.)
• Refer to page 93 for an inverter reset program example.
Resetting method
*1
page 73.)
Pr.349 = 0
*2
61.)
Pr.349 = 1
Network
operation
Allowed
Allowed
Allowed
Allowed
Allowed
Allowed
page 34.)
INVERTER SETTING
Operation mode
External PU
operation operation
Disallowed Disallowed
Allowed Allowed
Disallowed Disallowed
Allowed Allowed
Allowed Allowed
Allowed Allowed
Allowed Allowed
43
4