Mitsubishi Electric 800 Series Instruction Manual page 14

 For the FR-E820-0175 (3.7K) or lower, FR-E840-0170 (7.5K) or lower, and FR-E860-0120 (7.5K) or
lower
1.
Remove the inverter front cover. (Refer to the FR-E800 Instruction Manual (Connection) for instructions to remove the
cover.)
2.
Use a nipper or the like to cut off the bottom of the front cover for plug-in option.
2. Front cover for plug-in option
3.
Fit the L-shaped spacer, straight spacer, and junction connector to the plug-in option as shown in the figure on the
14. Fit the junction connector to the guide of the connector of the plug-in option, and insert the junction connector as far
as it goes. Fit the L-shaped spacer to the plug-in option so that the lower edge of the option placed on the ridge of the
spacer.
Ensure no burr is left.
page
13
INSTALLATION
2