Mitsubishi Electric 800 Series Instruction Manual page 77

Item
Second parameter
*7
changing
*1 When "100" is set in Pr.52 Operation panel main monitor selection, frequency setting is monitored during a stop and output frequency
is monitored during running.
*2 Write data is in hexadecimal, and only last two digits are valid. (The upper two digits are ignored.)
*3 Differs according to capacities.
*4 Setting from the remote register (RWw1) is also available.
*5 Turning OFF the power supply while clearing parameters with H5A5A or H55AA sets back the communication parameter settings to the
initial settings.
*6 Setting is valid only when Pr.544 = "0". When Pr.544 ≠ "0", set using RWw2 or RWw10, 12, 14, 16, or 18. (Refer to
*7 Reading or writing is available when the link parameter extended setting = "1 or 9".
*8 Gain frequencies can be written using Pr.125 (instruction code H99) and Pr.126 (instruction code H9A) also.
NOTE
• When the 32-bit parameter setting or monitor description are read and the read value exceeds HFFFF, the reply data will be
HFFFF.
76
DETAILS OF INPUT AND OUTPUT SIGNALS
Read/ Instruction
write code
Read or write of bias and gain parameters. For the details of setting values, refer to the
Read H6C
calibration parameter list of the FR-E800 Instruction Manual (Function).
H00: Frequency
H01: Analog value set in parameters
Write HEC
H02: Analog value input from the terminal
Description
*8
page 66)