Mitsubishi Electric 800 Series Instruction Manual page 25

3.
Cable insertion
Lift up the back of the plug cover, and insert the cable until it reaches the end. Insert each signal cable into the CC-Link
communication one-touch connector plug as shown in the following figure.
NOTE
• Insert the cable fully. Failure to do so may cause a crimping failure.
• A cable sometimes comes out of the head of the cover. In that case, pull the cable a little so that the cable stays under the
plug cover.
24
WIRING
5 4 3 2 1
Signal name
DA (Blue)
DB (White)
DG (Yellow)
Not used
SLD (Drain wire)