Inverter Option Specifications - Mitsubishi Electric 800 Series Instruction Manual

 Operation status indication LED
Item
L.RUN Lit when refresh data is properly received. Turns off when a data transmission is stopped for a certain period of time.
• Lit when a communication error occurs in the own station and flickers when settings of switch, etc. are changed while power is on.
L.ERR • Flickers when the Pr.542 or Pr.543 setting is changed.
Turn the power on again or turn the RES signal on. (Refer to
Lit during normal operation (5V is supplied in the board) (Lit even in the non-communication status.)
RUN
Flickers when the master station is CC-Link Ver.1 and the FR-A8NC is CC-Link Ver.2 compatible. (Refer to
SD Turns off when no data is transmitted.
RD Lit when the received data carrier is detected.
NOTE
• Set the station number using Pr.542 Communication station number (CC-Link). (Refer to
• Set transmission baud rate using Pr.543 Baud rate selection (CC-Link). (Refer to
1.3

Inverter option specifications

Item
Type Inverter plug-in option type, one-touch connector connection, online connector (T type (2 to 1)) supported
Power supply Supplied from the inverter
Number of units
42 units max. (Refer to
connected
Station type Remote device station
Number of CC-Link Ver.1: occupies one station, CC-Link Ver.2: occupies one station (selectable from among double, quadruple and
stations occupied octuple)
Communication
CC-Link dedicated cable, CC-Link Ver. 1.10 compatible CC-Link dedicated cable
cable
Description
page
Description
page 52 for the number of stations occupied), May be used with other equipment.
45, 47.)
page
page 47.)
PRE-OPERATION INSTRUCTIONS
page 10.)
45.)
9
1