Setting The Ip Address - Hitachi SVP F 00 Series Manual

Procedure
1. Right-click LAN1 (Local Area Connection 4), and then click Rename.
2. Change the name to Management(User).
3. Repeat step 1 and step 2 to rename the other three SVP network adapters as
follows.
Change the name of
this SVP adapter...
LAN1
LAN2
LAN3
LAN4
4. Leave the Network Connections window open. Then either configure the SVP for
bridge mode or configure the IP addresses for the SVP LAN ports to match the IP
addressing scheme of your subnet.

Setting the IP address

After renaming the internal SVP network adapters, perform the initial startup procedures
to specify the IP addresses for the SVP and storage system.
Procedure
1. Connect a PC to the LAN2 port on the SVP.
2. Log on to the SVP using the Remote Desktop Connection:
Chapter 19: Replacing the Hitachi Vantara-supplied SVP
...to this name
Management(User)
Maintenance
Management(CTL1)
Management(CTL2)
Service Processor Technical Reference
Setting the IP address
Adapter configuration
Bridge for the
management LAN
Maintenance LAN
Management LAN
Bridge for the
management LAN
255