Hitachi SVP F 00 Series Manual page 220

RMIClassLoaderHttps
RMIIFRegist
PreRMIServer
DKCManPrivate
SMI-S (SLP)
SMIS_CIMOM
CommonJettyStart
CommonJettyStop
RestAPIServerStop
DeviceJettyStart
DeviceJettyStop
Chapter 14: Changing and initializing SVP port numbers
Service Processor Technical Reference
Behavior when changing SVP port numbers
Using Hitachi Device Manager - Storage
Navigator
When using the raidinf command (a
program for obtaining configuration
reports and obtaining tier relocation logs)
to log on to Device Manager - Storage
Navigator, specify <SVP Change Port> in
addition to the SVP IP address or host
name.
When issuing the remote power ON/OFF
tool (RmtPsTool) command, specify <SVP
Change Port> for the Management Server
Port Number parameter.
When issuing the export tool command,
specify <SVP Change Port> in addition to
the SVP IP address using ip Subcommand
to the SVP IP address.
Using Hitachi Command Suite
Match the port number used in Hitachi
Command Suite to the new SVP port.
None
None
Using SMI-S:
Match the port number used in the SMI-S
communication to <SVP Change Port>.
Match the port number used in the SMI-S
communication to <SVP Change Port>.
For a storage system running firmware
version 83-03-01-xx/00 or later, register
the storage system, and then set it after
verifying the port numbers to be used
(see Viewing the port number to be used
in the SVP (on page 225)
None
None
None
None
None
)
220