Hitachi G800 Quick Start

1
Prepare for
Installation
2
Connect the
Hardware
1
1
Prepare for Installation
1. Unpack package contents.
CAUTION
LIFTING HAZARD
187.3 lbs
Lift with 3 people.
(85 kg)
Hitachi Virtual Storage Platform
1
G800
Prepare for
Quick
Installation Quick
2 3
Power Up Start
the System
Connect the
5
Hardware 4 Run the Initial
Start
Setup Wizard
7 Complete System
Run the
Setup
6
Initial Startup
Wizard
START START
Enable Hi-Track
Remote Monitoring System
Power, Fibre Channel,
iSCSI, and SAS
Cables (optional)
3
Power Up
the System
5
4
Run the
6
Initial Startup
Wizard
Enable Hi-Track
Remote Monitoring
System
Accessory
Box
Bezel
Controller
Software
Applications
Disk Drives
Power
Distribution
Units
Hitachi Virtual Storage Platform
Perform the
Initial Setup
7
Complete System
Setup
8
Go to Support Connect at
https://support.hds.com
and subscribe to receive
important technical bulletins.
2. Provide these
items.
Management
Console PC
(with NIC)
Additional
Wrist
Cables
Strap
User-Supplied
Rack (if not
ordered from
Hitachi)
Uninterruptible
Power Supply (UPS)
Rack
(optional)
G800 / F800
Quick
Start
START START
3. Install devices into
the rack.
SVP
Switch
Drive Trays
(units 2-4)
Controllers
(unit 1)
Do not turn on units until
instructed to do so.
HDS or User-Supplied Rack
Install the service processor (SVP) at the
top of the rack, and the controllers and
drive trays below it. Labels on the top of
the controller and drive trays identify the
units and their installation order. Install
the unit with the lowest number (for
example unit #1) at the bottom, and then
install the remaining trays (for example
unit 2, unit 3, and so on) in sequential
order above it.
NOTE