Drive Address Setting; Figure 15. Drive Address Setting - Hitachi HTS541616J9AT00 - Travelstar 160 GB Hard Drive Specifications

7.10

Drive address setting

A jumper placed on the interface connector determines the drive address. The three drive addresses are shown
below.

Figure 15. Drive address setting

Setting 1—Device 0 (Master) (no jumper is used)
Setting 2—Device 1 (Slave)
Setting 3—Cable Select
Setting 4—Never attach a jumper here
Setting 5—Never attach a jumper here
When pin C is grounded, the drive does not spin up at POR.
When the drive address is Cable Select, the address depends on the condition of pin 28 of the AT interface cable. If
pin 28 is ground (or low), the drive is a Master. If pin 28 is open (or logic high), the drive is a Slave.
7.10.1 Drive default address setting
The default setting of jumper at shipment is Setting 1: no jumper.
Travelstar 5K160 (PATA) Hard Disk Drive Specification
1 2
3 1
4 2
3 4 5
53 / 188