Uploading The Certificate To The Svp - Hitachi SVP F 00 Series Manual

Procedure
1. On the SVP, start a Windows command prompt as an Administrator.
2. Move the current directory to the directory where the tool
(MappApacheCrtInit.bat) is located. Issue the following command: C:\MAPP\wk
\Supervisor\MappIniSet\ MappApacheCrtInit.bat
3. At the message Press any key to continue the process..., enter an arbitrary
key.
4. Close the command prompt.

Uploading the certificate to the SVP

To you use an arbitrary certificate for SSL communications between the SVP and storage
system, upload the private key and the signed server certificate (public key) to the SVP.
This procedure assumes that:
The private key of the storage system and the signed server certificate (public key)
■
from the maintenance utility have been updated.
The private key (server.key file) and the signed public key certificate (server.crt
■
file) are in the X.509 PEM or X.509 DER format.
All users are logged out of Device Manager - Storage Navigator.
■
Procedure
1. On the SVP, start a Windows command prompt as Administrator.
2. Move the current directory to the directory where the certificate update tool
(MappL7SwitchGumSslCrtUpdate.bat) is located. Issue the following command:
C:\MAPP\wk\Supervisor\MappIniSet\
MappL7SwitchGumSslCrtUpdate.bat r[absolute path of the
certificate file]
3. At the message Press any key to continue the process..., enter an arbitrary
key.
4. Close the command prompt.
Note: C:\MAPP indicates the installation directory of the SVP. If you
specify an installation directory other than C:\Mapp, replace C:\Mapp
with the specified installation directory.
Note: C:\MAPP indicates the installation directory of the SVP. If you
specify an installation directory other than C:\Mapp, replace C:\Mapp
with the specified installation directory.
Chapter 11: Setting up SSL encryption
Service Processor Technical Reference
Uploading the certificate to the SVP
205