Hitachi SVP F 00 Series Manual page 270

9. When the following completion message appears, perform one of the following
steps:
To continue, click The setting has been completed. I will continue installation
■
and updating of the software.
To set port numbers, firewall settings, and anti-virus software, click The setting
■
is not completed. I will install and update the software after I complete the
setting.
10. Click Finish.
11. At the Environmental Settings window, click IPv4 or IPv6, and then enter the IP
address of the SVP and click Apply.
Chapter 19: Replacing the Hitachi Vantara-supplied SVP
Service Processor Technical Reference
Installing Hitachi Device Manager - Storage Navigator
270