Initializing Range Of Port Numbers To Be Allocated Automatically; Viewing The Port Number To Be Used In The Svp - Hitachi SVP F 00 Series Manual

Initializing range of port numbers to be allocated
automatically
You can initialize the range of the port numbers automatically allocated to the storage
system.
Before you begin
Verify the client PC is already connected to the SVP through a Remote Desktop
connection.
Procedure
1. On the SVP, start a Windows command prompt as an Administrator.
2. Change the current directory to the directory where the tool exists and run the
following command: C:\Mapp\wk\Supervisor\MappIniSet
\MappPortRangeInit.bat
3. The confirmation message for reallocation is displayed. To continue the processing,
enter y, and then press Enter. To cancel the processing, enter n, and then press
Enter.
A completion message appears. Press any key to continue.
4. Close the command prompt.

Viewing the port number to be used in the SVP

You can view the port numbers to be used in the SVP.
Before you begin
Verify the client PC is already connected to the SVP through the Remote Desktop
connection.
Procedure
1. On the SVP, start a Windows command prompt as an Administrator.
2. Change the current directory to the directory where the tool exists and run the
following command: C:\Mapp\wk\Supervisor\MappIniSet
\MappPortRefer.bat_[Serial number] (arbitrary)
The _ character indicates a space. The values in [ ] indicates a parameter.
When the serial numbers are omitted, the information of all the storage systems
registered in Storage Device List is displayed.
Chapter 14: Changing and initializing SVP port numbers

Initializing range of port numbers to be allocated automatically

Tip: C:\MAPP indicates the installation directory of the storage
management software and SVP software. If the installation directory is
not C:\Mapp, replace C:\Mapp with the appropriate installation
directory.
Service Processor Technical Reference 225