Table of Contents
Advertisement
Appendix
Testing the motion
sensor
You can observe the motion sensor's
LED indicator and test the performance
of the motion sensor.
1
Press M
2
Move to an area near the motion
sensor.
3
While moving near the motion
sensor, observe the LED indicator.
R When motion is detected, the
4
Note the areas where movement
is detected.
5
Press M
Adjusting the sensor
sensitivity
You can use the MHIGHN/MLOWN switch
(page 7) to adjust the sensor's
sensitivity. If the sensor often makes
incorrect detections, such as in areas
with frequent and substantial
temperature fluctuations, set the switch
to the MLOWN position.
Note:
R When the switch is in the MLOWN
position, the sensor detection range
is reduced by about half (compared
to when the switch is in the MHIGHN
position).
14
HNS102HM_(en_en)_0801_ver.021.pdf
N.
LED indicator lights in red.
N again.
14
Features available
when using the
[Home Network] app
Some of the motion sensor's features
that are available when using the
[Home Network] app are listed below.
For more information, refer to the
User's Guide (page 14).
– Alarm system
You can use the app to arm and
disarm the alarm system, confirm
the current status of the sensor, and
view a log of previous events.
– Sensor integration
You can configure the motion sensor
to trigger other system events, such
as camera recording, turning on an
electric device (such as a lamp), etc.
(Appropriate device required.)
– Telephone alert
You can configure the system to call
a preprogrammed phone number
when the motion sensor is triggered.
Accessing the User's
Guide
The User's Guide is a collection of
online documentation that helps you
get the most out of the [Home
Network] app.
1
iPhone/iPad
Tap
in the app's home screen.
Android™ devices
Tap
or press your mobile
device's menu button in the app's
home screen.
2
Tap [User's Guide].
2015/08/03
13:47:58
Advertisement
Table of Contents
