Beam-Axis Alignment - Panasonic SF4С Series Instruction Manual

Before Using this Device

2.7.6 Beam-axis Alignment

The beam-axis alignment differs depending on the mounting bracket used (MS-SFC-1 or
MS-SFC3). Follow either of the both procedures depending on which mounting bracket you use.
To align the beam axis, please proceed as follows:
For MS-SFC-3:
Procedure
1. Turn ON the power supply unit of the safety light curtain
2. Check that the digital error indicator (red) and the fault indicator (yellow) of
the emitter and receiver are off
If the digital error indicator (red) or the fault indicator (yellow) lights up or blinks,
refer to the chapter on troubleshooting (see page 103) and report this to the
maintenance staff in charge.
3. In case of using the standard mounting bracket MS-SFC-1 (accessory),
loosen the hexagon-socket head bolts (M5) which holds the standard
mounting bracket MS-SFC-1
4. Move the emitter to the left and right in order to determine the range of the
light received condition with the help of the beam-axis alignment indicator
(red)
5. Then, set the emitter in the center of this range
6. Similar to the step 4, perform the beam-axis alignment for the receiver
7. Tighten the standard mounting bracket MS-SFC-1 by the hexagon-socket
head bolt (M5)
8. Confirm that the beam-axis alignment indicators (green) in the display of the
emitter and receiver, operation indicator (green) and OSSD indicator (green)
light up
Receiver
54
SEN TRONIC
AG
Produkte, Support und Service
Emitter
Rugghölzli 2 Tel. +41 (0)56 222 38 18
CH - 5453 Busslingen Fax +41 (0)56 222 10 12
SF4C Safety light curtain
mailbox@sentronic.com
www.sentronic.com