Table of Contents
Advertisement
44
GETTING TO KNOW YOUR VEHICLE
Rotate the end of the lever upward, to the first detent
past the intermittent settings for low-speed wiper
operation. Rotate the end of the lever upward to the
second detent past the intermittent settings for high-
speed wiper operation.
Intermittent Wiper System
The intermittent feature of this system was designed for
use when weather conditions make a single wiping
cycle, with a variable pause between cycles, desirable.
For maximum delay between cycles, rotate the control
knob upward to the first detent.
The delay interval decreases as you rotate the knob
until it enters the low continual speed position. The
delay can be regulated from a maximum of about
18 seconds between cycles, to a cycle every one sec-
ond. The delay intervals will double in duration when
the vehicle speed is 10 mph (16 km/h) or less.
Windshield Washers
To use the windshield washer, push the washer knob,
located on the end of the multifunction lever, inward to
the second detent. Washer fluid will be sprayed and the
wiper will operate for two to three cycles after the
washer knob is released from this position.
If the washer knob is depressed while in the delay
range, the wiper will operate for several seconds after
the washer knob is released. It will then resume the
intermittent interval previously selected. If the washer
knob is pushed while in the off position, the wiper will
turn on and cycle approximately three times after the
washer knob is released.
To prevent freeze-up of your windshield washer system
in cold weather, select a solution or mixture that meets
or exceeds the temperature range of your climate. This
rating information can be found on most washer fluid
containers.
WARNING!
Sudden loss of visibility through the windshield could
lead to a collision. You might not see other vehicles or
other obstacles. To avoid sudden icing of the wind-
shield during freezing weather, warm the windshield
with the defroster before and during windshield
washer use.
Mist Feature
When a single wipe to clear off road mist or spray from
a passing vehicle is needed, push the washer knob,
located on the end of the multifunction lever, inward to
the first detent and release. The wipers will cycle one
time and automatically shut off.
NOTE:
The mist feature does not activate the washer pump;
therefore, no washer fluid will be sprayed on the wind-
shield. The washer function must be used in order to
spray the windshield with washer fluid.
RAIN SENSING WIPERS —
IF EQUIPPED
This feature senses moisture on the windshield and
automatically activates the wipers for the driver. The
feature is especially useful for road splash or overspray
from the windshield washers of the vehicle ahead.
Rotate the end of the multifunction lever to one of five
settings to activate this feature.
NOTE:
This feature can be programmed on/off through the
Uconnect system. Refer to "Uconnect Settings" in "Mul-
timedia" for further information.
The sensitivity of the system can be adjusted with the
multifunction lever. Wiper delay position 1 is the least
sensitive, and wiper delay position 5 is the most sensi-
tive. Position 3 should be used for normal rain condi-
tions. Positions 1 and 2 can be used if the driver
desires less wiper sensitivity. Positions 4 and 5 can be
used if the driver desires more sensitivity. Place the
wiper switch in the O (off) position when not using the
system.
NOTE:
•
The Rain Sensing feature will not operate when the
wiper switch is in the low or high-speed position.
•
The Rain Sensing feature may not function properly
when ice, or dried salt water is present on the
windshield.
•
Use of products containing wax or silicone may
reduce Rain Sensing performance.
The Rain Sensing system has protection features for
the wiper blades and arms, and will not operate under
the following conditions:
•
Low Ambient Temperature — When the ignition is
first placed in the ON position, the Rain Sensing
system will not operate until the wiper switch is
moved, vehicle speed is greater than 0 mph
(0 km/h), or the outside temperature is greater than
32°F (0°C).
Advertisement
Table of Contents
