Avoid Damage To The Device - Atmos Record 55 Operating Instructions Manual
With standard rail
Hide thumbs
Also See for Record 55:
- Operating instructions manual (55 pages) ,
- Operating instructions manual (52 pages)
Table of Contents
Advertisement
WARNING
Electric shock due to improper mains connection, incorrect handling of the
product or damaged product components.
Risk of burns, cardiac arrhythmias and even fatal injury.
•
Prior to each use, check for damage to the device and the power cable. Do not
operate the device if you notice any damage. In this case, clean and disinfect the
device and send it to ATMOS for repair.
•
Disconnect the device from the mains supply prior to cleaning or disinfection.
•
Disconnection of the device is only possible by removing the power plug from the
power supply.
•
Position the device so that it can be easily disconnected from the mains power
supply.
•
Never connect the device to a mains power supply without a protective conductor.
•
Never touch the plug or power cable with wet hands.
•
Only use the power cable in dry surroundings. The surroundings must be non-
conductive.
•
Ensure that no liquid penetrates the device. If liquid enters the device, operation of
the device must cease immediately. In this case, clean and disinfect the device and
send it to ATMOS for repair.
•
Only use proper power cables and extension cables.
•
Never touch the device interface and the patient at the same time!
•
Only use original accessories and original spare parts from ATMOS.
•
Pay attention to the period tests in chapter 6.0 „Maintenance and service".
•
Assembly, new settings, alterations, extensions and repairs may only be carried out
by authorised persons.
•
Do not modify the device without the manufacturer's permission.
2.3 Avoid damage to the device
ATTENTION:
Storage and operation in an unsuitable environment.
Risk of damage to the product.
•
Please observe the ambient conditions regarding transport, storage and operation.
•
After transportation of the device at low temperatures and prior to first start-up
it should be kept at room temperature for at least six hours. If the device is not
acclimatized it may not be used as the diaphragm of the pump could be damaged.
Notices for your safety
11
Advertisement
Table of Contents
