ITT GOULDS PUMPS ICO i-FRAME Installation, Operation And Maintenance Manual page 90

6.8 Reassembly
NOTICE:
Casing Gasket (400) must not be installed and feature must be clean and free of foreign mate-
rials.
19. Subtract A2 from A1 and record in the A field (A = A1-A2) -- Refer to
method on page
20. Continue to Step 22 for casing cover (161) to sleeve (524) measurement -- Refer to
neric gauge bar method on page
21. Measure from top of appropriate K14153A bar to impeller (230) back hub face as shown in
44: Assembly arrangement on page 86
22. Subtract H from A1 to and record in A field (A = A1-H) -- Refer to
method on page
Figure 47: Casing cover to sleeve measurement
23. Place bar (Goulds or Generic) across casing cover (161) as shown in
sleeve measurement on page
field.
24. Subtract H from B1 and record in field B (B = B1- H) -- Refer to
measurement on page
25. Refer to Table 7: "C" Value table on page 96
this value in "C" field.
26. Refer to gasket
NOTICE:
Most common gasket type is AFM-34.
27. Determine shim (525) height by using the following formula: SHIM HEIGHT = A + B - C + D.
28. With shim thickness determined, combine shims as needed to approximate this value.
88
87.
87.
and record value in A1 field.
87.
88, measure top of bar to sleeve (524) shoulder, and record in B1
88.
Table 8: "D" Value Table on page 97
Model ICO i-FRAME, ICOH i-FRAME Installation, Operation, and Maintenance Manual
Figure 46: Generic gauge bar
Figure 45: Goulds gauge bar
Figure 47: Casing cover to
Figure 47: Casing cover to sleeve
and match pump size with fluid temperature - Record
and record value in "D" field.
Figure 46: Ge-
Figure