Replacing The Upper Section Cable Harness; Replacing The Control Box - Husqvarna Automower 210 C Technical Manual

5.7 Replacing the upper section
cable harness
Upper section cable harness in the Automower
connects the control box with:
1. Display circuit board.
2. Left collision sensor.
3. Right collision sensor.
4. Lift sensor.
To change the cabling:
1. Dismantle the body and chassis.
2. Remove the cabling from the control box,
display circuit card, the collision sensors and
the lift sensor.
3. Replace with a new upper section harness
and connect.
4. Check that the mower works.
5. Fit the chassis and body.

5.8 Replacing the control box

A mower's operating information is stored in the
control box. This information, with the help of the
service program Autocheck, can be saved in a file
on a computer and then transferred back to the
mower once the control box has been replaced,
see Operating history: Copy all data to new
control box, page 75.
1. Dismantle the body and chassis.
2. Remove the cabling, battery cable and any
GSM module.
3. Unscrew the four screws, torx 20, holding the
control box.
IMPORTANT INFORMATION
Only hold a circuit board by its edges. Never
touch the card's components and pin
terminals.
92 - English
5. REPAIR INSTRUCTIONS
®
1.
4.
2.
3.