Trouble Shooting; Fault Messages - Husqvarna Automower 210 C Technical Manual

6. Trouble shooting

The fault detection section consists of two main areas,
Fault messages and Fault symptoms. Each fault
message and fault symptom is explained using one or
more possible causes of the problem, followed by one
or more solutions.
When an Husqvarna Automower
correctly, first take the following actions before
continuing with trouble shooting:
1. Update the mower program in Automower
latest edition. Many problems are solved directly
by the new mower program, see Table 2: Version
of the mower program on page 8.
The latest version of the mower program can be
downloaded from the support site:
http://support.automower.com.
2. Reset the factory settings on the mower by
selecting Commands - Make factory sett. (shortcut
1-3), enter the PIN code and press YES or from
Autocheck: Tools, Make factory settings.

6.1 Fault messages

All fault messages that can be displayed are listed below. Autocheck can also be used for the menu
functions mentioned. This primarily applies to 210 C without a display.
Table 7: Fault messages
Fault message
Outside
104 - English
6. TROUBLE SHOOTING
does not work
®
to the
®
Cause
The boundary wire's connections to the
charging station/loop generator have
crossed. When a problem appears while
the mower is inside the installation.
The boundary wire is too close to the
edge of the working area. When a
problem appears while the mower is
outside the installation.
The downward slope by the boundary
wire is too large. The mower has probably
skidded and rolled outside the installation.
When there are several adjacent
installations and the mower is in the
vicinity of a neighbouring installation, the
message may be due to its own loop
signal being lost and the mower believing
it is outside of the neighbouring
installation.
If this occurs in isolated areas it may be
due to interference from metallic objects
(perimeter fence, reinforcement bar) or
buried cables in the vicinity. When a
problem appears while the mower is
inside the installation.
The boundary wire has been routed the
wrong way around an island. When a
problem appears while the mower is
inside the installation.
Action
Try swapping the connections
Check that the boundary wire has been routed
correctly.
Move the boundary wire. Equip the mower with wheel
brushes for better grip.
Switch to another PIN code via Settings - Safety - PIN
code (Shortcut 4-1-1).
Try moving the boundary wire.
Check that the boundary wire has been routed in
accordance with the installation instructions.