Husqvarna Automower 210 C Technical Manual page 80

4. AUTOCHECK, SERVICE PROGRAM
Settings: Square mode cutting
Square mode cutting is when the mower cuts the grass
in a square pattern, see 1.6 Square mode cutting on
page 11.
To change the frequency for Square mode cutting:
1. Use the controller to increase or decrease the
percentage. A high percentage means that the
mower runs in square mode cutting more seldom
and vice versa.
2. Click Save.
To deactivate Square mode cutting:
1. Check the Square mode cutting box. A checked
box means that this function is turned off. The
mower will never run in square cutting mode.
2. Click Save.
Settings: Wheel motor speed
(only 230 ACX)
The wheel motor speed can be adjusted on the
Automower 230 ACX. Two speeds are available,
®
Normal and Reduced. Unless the installation requires
full speed for the mower to be able to mow the entire
surface, the speed should be reduced. This protects
the machine from hard collisions and therefore
unnecessary wear and tear.
To change Wheel motor speed:
1. Use the controller to adjust between Normal and
Reduced speed.
Click Save.
Settings: Reset
Click on Factory settings to restore all settings on
the mower to the original values. To view these
settings, see Table 3: Factory settings, page 42. All
settings except the selected language and PIN code
are reset.
80 - English