Husqvarna Automower 210 C Technical Manual page 47

When any of the following can be found in the working
area, the installation of a guide wire is recommended.
• Narrow passages.
In passages where the distance between the
boundary wires is less than 3 metres (10 ft), it is
recommended to install a guide wire through the
passage. This is a better solution than allowing
Automower to follow close to the boundary wire
®
by setting a low Corridor width value.
• The boundary wire runs along a steep slope
(steeper than 35 %).
When Automower ®
that runs along a steep slope, the mower will
change direction and run away from the
boundary wire.
• Numerous or large islands.
If Automower ® is permitted to follow the
boundary wire it may circle an island roughly
twice before it leaves the island and once again
searches for the boundary wire.
• The route to a remote area is long or
complicated.
When Automower ®
wire to or from a remote area and the route along
the boundary wire to the area is long or
complicated.
• The boundary wire runs across a long slope
(steeper than 10 %).
When Automower ®
across a slope (steeper than 10 %) the mower
must compensate for the slope. The mower must
stop relatively often to check the strength of the
loop signal and then follow the boundary wire at
a slower speed. The risk of the mower running
outside of the working area due to skidding
increases.
• The charging station is positioned on an island.
When there is more than 4 metres between the
charging station and the outer edge of the
boundary wire, it can take a long time for
Automower ® to find the charging station when it
follows the boundary wire. There is a risk of the
mower following the outer edge of the working
area 2 – 3 turns before it changes direction and
starts to follow the loop at another spot.
3. INSTALLATION
follows the boundary wire
shall follow the boundary
follows the boundary wire
English - 47