Replacing The Battery; Replacing The Battery, Control Box - Husqvarna Automower 210 C Technical Manual

5.15 Replacing the battery

1. Dismantle the body and chassis.
2. Press down the catch on the battery cable's
connector and pull the cable off of the control box.
3. Loosen the two screws, Torx 20, and the holder
over the battery. To access the batteries on the
260 ACX model, the ultrasonic circuit first has to
be uninstalled.
4. Lift out the battery.
5. Fit the new battery. The battery on the 210 C,
220 AC and Solar Hybrid should be installed in
the front compartment. Be sure to insert the
battery with the text "THIS SIDE DOWN" facing
downwards. If the battery is inserted incorrectly,
this can result in interference in the mower's rear
loop sensor.
6. Check that the battery works
7. Fit the chassis and body.
NOTE! After replacing the battery you should reset
Charges OK , which a measurement of the battery age.
This is done from Autocheck via Operating history,
Clear Charges OK .
5.16 Replacing the battery, control
box
(not applicable to 210 C)
There is a lithium battery on the control box that
provides power to the mower's clock when the main
battery is replaced or is fully discharged after, e.g.
winter storage. The lithium battery must be replaced
when the mower's clock starts to show strange times
or when the voltage drops below 2.5V. The normal life
span is several years.
Battery type: CR 2025 3V.
1. Dismantle the body and chassis.
2. Remove the old battery from its holder on the
control box.
3. Insert the new battery, with + side facing
upwards.
4. Fit the chassis and body.
96 - English
5. REPAIR INSTRUCTIONS