Replacing The Blade Motor - Husqvarna Automower 210 C Technical Manual

5.17.3 Lift sensor
1. Remove the cable from the lift sensor.
2. Unscrew the screw, torx 20, and lift the sensor
from its holder.
3. Fit the new sensor.
4. Check that the lift sensor works.
Check that the sensors work via Tools - Test -
Sensors (shortcut 5-2-5). When the mower has been
lifted, i.e. when the lift sensor is activated, the mower
should indicate YES on the display.
If the lift sensor still does not work after replacement,
check that the pillar and magnet have been fitted
correctly. The magnet must be fitted on the right-hand
pillar and it must be square to the chassis. Two
dashes on the chassis mark where the magnet
should be seated.
5.17.4 Ultrasonic sensor
1. Open the cover for the cutting height adjustment.
2. Remove the cable from the ultrasonic sensor
using a bayonet socket. Also undo the "Christmas
tree" that holds the cable in place.
3. Turn the mower over and unscrew the two screws
of the plastic holder that keep the ultrasonic
sensor in place.
4. Remove the ultrasonic sensor from its holder.
5. Carefully install the new ultrasonic sensor and be
sure to place it in the middle of the chassis
component.
6. Test the ultrasonic sensor to be sure that it works.

5.18 Replacing the blade motor

1. Turn the Automower
2. Unscrew the skid plate (4 screws torx 20), blade
disc (3 screws torx 20) and the hub (stop screw
hex 2).
3. Unscrew the four screws, torx 20, holding the
blade motor.
4. Turn the Automower
cutting height adjustment.
5. Place your fingers under the edge of the wheel for
the cutting height adjustment and lift off the wheel.
6. Remove the connector to the blade motor.
7. Replace the blade motor with a new motor and
connect the connector.
8. Place the Automower
9. Hold the blade motor and screw in position.
10. Check that the mower motor works.
11. Replace the wheel for the cutting height
adjustment and close the cover.
12. Fit the hub, blade disc and skid plate.
98 - English
5. REPAIR INSTRUCTIONS
® upside down.
and open the cover for the
®
on its side.
®