Replacing Hydrostatic Cable - Husqvarna Rider 100 series Workshop Manual

Replacing the hydrostatic cable
Rider 111 B/112 C/115 C/120 C
Removing the hydrostatic cable
1 Remove the frame cover and the front cover.
2 Loosen the hydrostatic transmission cable
locking nut 1/4 turn.
3 Remove the front hydrostatic cable clamp that is
fastened inside the center console.
4 Cut off the plastic tie around the cable at the
frame situated in front of the left front wheel.
1
5 Loosen the M5 nut (1) and remove the locking
spring (2) by the hydrostatic transmission's rear
link joint. Loosen the clamp (3) holding the cable
cover.
Repair instructions
3
2
English – 39