Husqvarna Automower 210 C Technical Manual page 79

4. AUTOCHECK, SERVICE PROGRAM
To save changed settings: Pres the Save button at the
top right. Note that the settings are only saved for the
program that is displayed at that time. It is also possible
to copy settings from one program to another. To copy
settings: Select the program from where the settings are
to be copied by clicking on the tab for the relevant
program. Then select the program to which the settings
are to be copied in the menu bar Copy to.....
Settings: Miscellaneous
On the Settings, Miscellaneous menu there are a
number of special functions, these are described
below.
Settings: Special
In certain cases, you may need to temporarily modify
the mower's Special settings including Loop detection,
Demo mode, STOP button override, Square mode
cutt. and Wheel motor speed.
A mower's Loop detection sometimes may need to be
temporarily turned off. This may be when an
Automower ® needs to be demonstrated when a
charging station and boundary wire have not been
installed, i.e. at a customer's home.
NOTE!
Remember to reactive loop detection again.
To deactivate loop detection:
1. Deselect the Loop detection checkbox.
2. Click on Save.
To activate loop detection again:
1. Select the Loop detection checkbox.
2. Click on Save.
Settings: Demo mode
(only 220 AC and 230 ACX , without GSM
software)
In order to make it easier to demonstrate an
Automower it is equipped with a demo mode. You can
®
use different settings in the different programs for
Demo mode.
To activate demo mode:
1. Select the Demo mode checkbox.
2. Click on Save.
When the function is activated the Automower
without starting the blade disc. The mower varies
running with charging at four minute intervals.
Settings: STOP button override
When STOP button override is activated, the
Automower ® can be started and stopped with the help
of the number 0 instead of the STOP button.
To activate STOP button override:
1. Check the STOP button override box.
2. Click Save.
® works
English - 79